SPLITTERS
  Standard 3, 5 or 11 output 
  Enhanced five output
  Enhanced wall mount
  Bi-directional hub / RDM
  Electronic patch bay

SIGNAL ROUTERS
  Electronic patch bay
  Passive A/B switches

WIRELESS DMX512
  Marconi TX
  Marconi Splitter
  Marconi LV

MERGERS
  Enhanced 2,3,4,5 or 6 input
  Enhanced wall mount

POWER SUPPLIES
  LED300: 24V 300W
  LED100: Battery & Wireless
  Class 2 Transformer

WALL PLATES
  Passive XLR plates
  Buffered DMX512 plates

MOUNTING OPTIONS
  Rack kits
  Product mounted in J-Box

DIMMERS
  DMX8DIM - 8 Channel Dimmer

CUSTOM & OEM
  Click Here

INTERFACES
  Analog to DMX 48 channel
  RS-232 to DMX
  DMX to DMX
  DMX to AMX192
  DMX to Analog 24 & 96 channel
  DMX to CMX / CMX to DMX
  DMX to Strand D54 
  DMX to DALI
  DMX to Microplex/LMX/Ultraplex
  DMX to RS-232
  DMX to Solid State Relay 96 Ch.
  DMX iPlayer interface
  DIN-rail mounted
  Pork Chopper - Hog II Overdrive
  Start Code Stripper

CONSOLES
  Apathy: Single channel console
  Preset 10 architectural
  Preset 10 architectural 2
  Preset 10 portable
  RAD: Remote Address Device
  Rerun architectural 
  Rerun portable 
  Rerun rack mount 
  Entry Station Two

DMX TESTERS
  DMX512 Line Tester
  GIZMO: DMX512 test box

OTHER DMX STUFF
  XLR Terminator w/ LED
  XLR Economy terminator
  RJ45 Terminator

	Links   Basic Spec.   Photos   Pricing   Manual   Datasheet PDF Files   Manual (40KB)   Datasheet (202KB) Related Products   Rack Kits
model: 2322DMX

The RS-232 to DMX interface allows advanced A/V control systems and computers to operate standard DMX512 devices such as dimmers and moving lights. It can also be used to allow an RS-232 based control system to receive DMX512 data. The RS-232 protocol used for this communication is made up of simple ASCII strings sent or received at 9600 baud. The interface can set and fade DMX channels to specific levels. It can also record and play 20 presets, each with individual fade times. The interface can be used to capture incoming levels produced by an outside DMX source. The RS-232 port appears on the front panel as a standard DB-9 connector. Another RS-232 port is available on the rear panel through a 3 pin female XLR connector. Only one of these connections can be used at a time. For simple operation, the Windows Hyperterminal program can be used to communicate with the interface.

Doug Fleenor Design is a proud member of: