 |
 |
 |
(805) 481-9599 |
||
     |
||
Inline isolator
Isolation amplifiers
DIN-rail isolator
SPLITTERS
Standard 3, 5 or 11 output
Enhanced five output
Enhanced wall mount
Bi-directional hub / RDM
Electronic patch bay
SIGNAL ROUTERS
Electronic patch bay
Passive A/B switches
WIRELESS DMX512 
Marconi TX
Marconi Splitter
Marconi LV
MERGERS
Enhanced 2,3,4,5 or 6 input
Enhanced wall mount
POWER SUPPLIES
LED300: 24V 300W
LED100: Battery & Wireless
Class 2 Transformer
WALL PLATES
Passive XLR plates
Buffered DMX512 plates
MOUNTING OPTIONS
Rack kits
Product mounted in J-Box
DIMMERS
DMX8DIM - 8 Channel Dimmer
1 Ch. line voltage
6 Ch. line voltage
2 Ch. low voltage contacts
6 Ch. low voltage contacts
INTERFACES
Analog to DMX 48 channel
RS-232 to DMX
DMX to DMX
DMX to AMX192
DMX to Analog 24 & 96 channel
DMX to CMX / CMX to DMX
DMX to Strand D54
DMX to DALI
DMX to Microplex/LMX/Ultraplex
DMX to RS-232
DMX to Solid State Relay 96 Ch.
DMX iPlayer interface
DIN-rail mounted
Pork Chopper - Hog II Overdrive
Start Code Stripper
CONSOLES
Apathy: Single channel console
Preset 10 architectural
Preset 10 architectural 2
Preset 10 portable
RAD: Remote Address Device
Rerun architectural
Rerun portable
Rerun rack mount
Entry Station Two
DMX TESTERS
DMX512 Line Tester
GIZMO: DMX512 test box
OTHER DMX STUFF
XLR Terminator w/ LED
XLR Economy terminator
RJ45 Terminator
Basic Specification
model: 123, 125, 1211
| Input circuit: | EIA-485 receiver with 120 ohm termination resistor between +Data and -Data (Units with feed through connectors do not have internal termination) |
||||||||
| Input signal: | 0.2 volts minimum, 12 volts maximum | ||||||||
| Output circuit: | EIA-485 driver | ||||||||
| Connectors: | Gold plated 5 pin Neutrik D-1 Series (3 pin connectors or terminal blocks optional) |
||||||||
| Feed through: | A non-isolated feed through connector is standard on the eleven output model and is optional on the one, three, and five output models. | ||||||||
| Isolation: |
2500 volt optical coupler, 1500 volt split bobbin transformer |
||||||||
| Power input: |
100 - 120 volts, 50/60 hertz, 12 watts (208 - 240 volt optional) |
||||||||
| Color: |
Top, bottom and sides: Silver hammer tone |
||||||||
| Size: |
|
||||||||
Doug Fleenor Design is a proud member of:
Doug Fleenor Design, Inc.
396 Corbett Canyon Road
Arroyo Grande, CA 93420
USA