 |
 |
 |
(805) 481-9599 |
||
     |
||
Inline isolator
Isolation amplifiers
DIN-rail isolator
SPLITTERS
Standard 3, 5 or 11 output
Enhanced five output
Enhanced wall mount
Bi-directional hub / RDM
Electronic patch bay
SIGNAL ROUTERS
Electronic patch bay
Passive A/B switches
WIRELESS DMX512 
Marconi TX
Marconi Splitter
Marconi LV
MERGERS
Enhanced 2,3,4,5 or 6 input
Enhanced wall mount
POWER SUPPLIES
LED300: 24V 300W
LED100: Battery & Wireless
Class 2 Transformer
WALL PLATES
Passive XLR plates
Buffered DMX512 plates
MOUNTING OPTIONS
Rack kits
Product mounted in J-Box
DIMMERS
DMX8DIM - 8 Channel Dimmer
1 Ch. line voltage
6 Ch. line voltage
2 Ch. low voltage contacts
6 Ch. low voltage contacts
INTERFACES
Analog to DMX 48 channel
RS-232 to DMX
DMX to DMX
DMX to AMX192
DMX to Analog 24 & 96 channel
DMX to CMX / CMX to DMX
DMX to Strand D54
DMX to DALI
DMX to Microplex/LMX/Ultraplex
DMX to RS-232
DMX to Solid State Relay 96 Ch.
DMX iPlayer interface
DIN-rail mounted
Pork Chopper - Hog II Overdrive
Start Code Stripper
CONSOLES
Apathy: Single channel console
Preset 10 architectural
Preset 10 architectural 2
Preset 10 portable
RAD: Remote Address Device
Rerun architectural
Rerun portable
Rerun rack mount
Entry Station Two
DMX TESTERS
DMX512 Line Tester
GIZMO: DMX512 test box
OTHER DMX STUFF
XLR Terminator w/ LED
XLR Economy terminator
RJ45 Terminator
Basic Specification
model: DINTAP
| Input circuit: | EIA-485 receiver with series self resetting fuses (PTC) and transient absorbing diodes. |
| Input protection: | Not damaged by continuous 120VAC line cross or up to 5KV transients. |
| Input isolation: | 750 volt DC/DC converter, 2500 volt optical coupler. |
| Input termination: | 120 ohm termination circuit may be switched in or out via external jumper |
| Input signal: | 0.2 volts minimum, 12 volts maximum |
| Output circuit: | EIA-485 driver with self resetting fuses and transient absorbing diodes. |
| Output protections: | Not damaged by continuous 120VAC line cross or up to 15KV transients. |
| Wire size: | 24-14 AWG |
| Connector: | Phoenix Contact MSTB series 12 position. |
| Supplied male header: Phoenix part number MSTBA2,5/12-G-5,08 | |
| Supplied mating female connector: Phoenix order number 1757116 | |
| Connector pin outs: |
1 - DMX512 common (tied to pin 7) |
| Power input: | 12 to 24 Volts DC, 0.3 Amps |
| Color: | Phoenix Contact green |
| DIN-rail: |
15 mm wide top-hat rail (EN 50045, BS 6273) |
| Size: | 1" (25 mm) wide, 3.125" (79 mm) high, 3.5" (90.5 mm) deep |
Doug Fleenor Design is a proud member of:
Doug Fleenor Design, Inc.
396 Corbett Canyon Road
Arroyo Grande, CA 93420
USA