 |
 |
 |
||
 |
 |
|
||
|
|
|
||
|
|
|
||
Basic Specification
|
|||||||||||||||||||||||||||||||||||||
| Input circuit: | EIA-485 receiver with series self resetting fuses (PTC) and transient absorbing diodes. |
| Input protection: | Not damaged by continuous 120VAC line cross or up to 5KV transients. |
| Input isolation: | 600 volt DC/DC converter, 2500 volt optical coupler. |
| Input termination: | 120 ohm termination circuit may be switched in or out via external jumper |
| Input signal: | 0.2 volts minimum, 12 volts maximum |
| Output circuits: | |
| 0-10V analog: | LM324 op amp w/ series 1N4004 diode. 15mA Max. short circuit protected. |
| 0-10V high current: | 2N3904 emitter follower. 150 mA Max. not short circuit protected! |
| Dry contact relay: | Aromat JQ series high capacity type. 5 amps 30VDC, 10 amps 125VAC |
| Optical coupler: | H11A1. Max. output current: 5mA. Max. output voltage: 30VDC |
| Connector: | Phoenix Contact MSTB series 12 position. |
| Supplied male header: Phoenix part number MSTBA2,5/12-G-5,08 | |
| Mating female connector (optional): Phoenix part number MSTBT 2,5/12-ST-5,08 |
|
| Connector pin outs: | 1 - DMX512 common 2 - DMX512 data - 3 - DMX512 data + 4/5 - Jumper together to terminate DMX512 input with 120 ohms 6 - 0-10V analog out 7 - common DC supply (15 - 24 VDC) 8 - positive DC supply (15 - 24 VDC) 9/10 dry contact relay 11 - optical coupler's negative pin (NPN emitter) 12 - optical couplers positive pin (NPN collector) |
| Power input: | 15 - 24 volts DC, 0.5 amps plus connected load |
| Color: | Phoenix Contact green |
| Size and weight: | 3 1/4" wide, 3 3/4" high, 1" deep, 6 oz. |
